Profile View #

The Profile View will be automatically generated for gravity networks (sewerage/drainage) synchronized from MiTS to Civil 3D. The generated diagram should correspond with the Long Sections in MiTS.

Steps: #

1. Each profile view has been set to the dedicated Genabler Stylings. To check or update the stylings, users may navigate to the Profile View Properties.

Select any of the Profile Views for the network > Right-click > Click on Profile View Properties

2. The Profile View is also set to follow the dedicated Genabler Bandsets Selection. To check or update the bandsets selection,

Under the Gravity Networks Automation section, click on the ‘Profile View’ dropdown > Click on ‘Change Profile View Bandsets’

3. To clear the Profile View,

Under the Gravity Networks Automation section, click on the ‘Profile View’ dropdown > Click on the ‘Clear Profile View’ button

Gravity Table #

This is a feature that allows users to add a Sumps and Pipes/Drains Table following the dedicated Genabler Styling.

Steps: #

1. Go to the MES Tab. Navigate to the Gravity Networks Automation section on the top ribbon.

2. Click on the dropdown of the ‘Gravity Table’ button. Click on ‘Add Table’.

3. The software will launch the Pipe Table Creation. Set the Table Style (by default, it is set to the dedicated Genabler Styling), Network, and Table Configurations (rows, columns, table behavior, etc.).

4. Click OK. Select the upper left corner to place the table on the drawing. Once the table has been set, the software will open up the Structure Table Creation, which requires users to set the stylings and table behaviors.

5. Click OK to place the Structure Table. Do note to place the Sumps Table at a gap from the Pipes/Drains Table to prevent overlapping between the two tables.

Networks Labeling #

Each of the structures (nodes) and pipes/drains is labeled with the properties, following the dedicated Genabler Stylings.

Steps: #

1. To check or update the stylings, users may navigate to the Structure Label Style by,

Selecting any of the labels of the network > Right-click > Edit Label Style

2. To update the properties displayed as the label,

Under the Gravity Networks Automation section, click on the ‘Label’ dropdown > Click on ‘Change Plan Label’

3. To clear the Labels,

Under the Gravity Networks Automation section, click on the ‘Label’ dropdown > Click on the ‘Clear Plan Label’ button