Note: This guide is ONLY applicable for synchronization from MiTS to Civil 3D.

Step 1: Setting the network catalog #

‘Apply Genabler Stylings‘ parameter and the Genieko Part List library will only be enabled if the machine has been set to Genieko Catalog.

To do so, you may refer to the guide provided here.

Step 2: Applying Genabler Stylings #

Applying Genabler Stylings automatically styles up your drawing by equipping it with Genieko (Pipe Network) and GeniekoMin (Pressure Network) Part Lists, as well as dedicated Object and Label Styles for the road corridors and utilities profiles.

Steps: #

• In the Civil 3D drawing file, go to the MES Toolbar and click on ‘Project’.

• The drawing file will need to be bound to a MiTS file following the steps here.

• On the Genabler Tab, check the box next to ‘Apply Genabler Stylings‘.

• Then, the software will throw a notification, “The drawing has not been styled up with Genabler Stylings. Proceed to Style Up the drawing?” as in the image below. Click Yes.

• The software will take a few seconds to upload the Genabler Stylings to your drawing. Once the stylings have been uploaded, the software will notify users, “Genabler Style Up completed successfully“. Click OK to close the notification.

• At the end of this step, please ensure the checkbox appears as in the image below.