by Ngu Soon Hui | Dec 5, 2017 | Blog, MiTS 1, Troubleshooting/Tips
1.0 Issue (between platform) Longer berm is at the top instead at the bottom which may cause failure in construction due to inadequate support to carry the load at the bottom. Image 1 Full berm is located at the above part 1.1 How Does It Happen Project reference :...
by Ngu Soon Hui | Nov 15, 2017 | Blog, MiTS 1, Troubleshooting/Tips
How to create platform for retaining wall Image 1 *not drawn in scale Project reference : EW3D 1.0 Issue Retaining wall and slope are needed to be constructed between two platforms as shown in Image 1. Reference as in the project attached, it is situated between...
by Ngu Soon Hui | Nov 1, 2017 | Blog, MiTS 1, Technical Documentation
There are some changes in MiTS 3 when it comes to the calculation of the verge slope ratio MiTS 1/MES Module: Road Go to: > Cross Section Detailing As shown above, the verge slope is 1:3.4. Go to: Options >> Parameters >> Analysis >> Design As stated above, the verge...
by Ngu Soon Hui | Oct 30, 2017 | Blog, Troubleshooting/Tips
Here are the steps to generate long section of pipeline. Single Pipe 1. Open project file >> Water Reticulation >> Input >> Analyze 2. Click Key Plan Output >> Click on particular pipe line >> Right Click >> Click Gen Long...
by Ngu Soon Hui | Sep 20, 2017 | Blog
MES Modules Installation Steps These installation steps can be applied for all MES Modules (DraNet, EW3D, LoopwinPlus, PondCAD, SewNet and MES Road) MES Modules (eg: EW3D) 1. Open EW3D folder 2. Right-click and select ‘Run as administrator 3. Click ‘Next’ 4. Select ‘I...
by Ngu Soon Hui | Jul 20, 2017 | Blog
If you encounter this problem, please follow steps provided below: Diagnosis 1: You might not have vdraw convertor properly installed 1. Download VC++ 2008 SP1. 2. Uninstall old vector draw converter file (if it exists). 3. Install the latest one, please download it...
