by Ngu Soon Hui | May 22, 2018 | Announcements, Blog, MiTS 1, MiTS 2, MSMA
SUStoM stands for Sarawak Urban StormWater Management. It is a planning standard to incorporate stormwater management into the design in order to minimize environmental degradation and improve aesthetic as well as recreational appeal of areas in Sarawak. As a...
by Ngu Soon Hui | Apr 26, 2018 | Blog, MiTS 1, Troubleshooting/Tips
MiTS 1 Existing Road To change the gradient of carriageway, shoulder and verge of existing road, go to: Carriageway Super-elevation > Spread Input > Adjust Cross Slope Rate % value Shoulder Road Width > Adjust Shoulder Cross Slope,% in Properties tab on RHS...
by Ngu Soon Hui | Apr 26, 2018 | Blog, MiTS 1, Troubleshooting/Tips
For Slope Out, for cut / fill hatching, the slope will be generated starting from the ‘Platform level’ and will stop until it reaches Original Ground Level or Neighboring Platform Level or whichever comes first. For Slope in ( internal slope), the slope in between...
by Ngu Soon Hui | Apr 12, 2018 | Blog, MiTS 1, Troubleshooting/Tips
Sometimes when user modelling their vertical alignment, they might encounter problem where the number of points vs lines vs curves not tally which resulted in an error and cannot proceed to analyse. *please refer image attached User may do some checking on the...
by Ngu Soon Hui | Apr 6, 2018 | Blog, MiTS 2, Troubleshooting/Tips
1.0 Issue: MiTS 2.0.44.0 onwards won’t be importing road module generated in MiTS 1 into MiTS 2 as Earthworks Platform. This is because the algorithm between these two versions is slightly different which results as per examples below. Example MITS 1 MITS 2 Different...
by Ngu Soon Hui | Feb 2, 2018 | Blog, MiTS 1, Troubleshooting/Tips
If users encounter such error shown below, you may follow the following steps to encounter the problem. Steps: Open project > Analyze > Click on 3D View Error message shown in Image 1 pops up Image 1 Error message pops up when generating 3D View Solution: Click...
